- .25dB maximum insertion loss, better than -20dB return loss from 88-108MHz. Maximum insertion loss occurs at 108MHz.
- RF connectors are not included. A coax can be soldered directly or PC mount N connectors may be used. We do offer an aluminum enclosure for this filter: Visit this page: Aluminum Enclosure
- The components used are Semco 500V metal cased micas and #14 awg machine wound inductors. This design is based on an Elenos exciter output section.
- Mounts to customers chassis with 8-32 screws. 1/4 inch PCB standoffs or washers are required between the bottom of the PCB and chassis. Installing the filter in a metal chassis is suggested to provide shielding and good thermal conductivity in high power installations.
- This low pass filter is best suited for our 15, 45, 80, 150 and 300W pallets.
- This low pass filter is intended for use in 50 ohm systems only.
- International bidders are welcome but please review our International Shipping Policy. International bidders must use Paypal, wire transfer or Western Union. Buyer pays actual shipping costs. Please request a shipping quote before bidding to avoid surprises.
- For US bidders in the lower 48, shipping is $7.00 flat rate with FED-EX ground or $12.00 with FED-EX express.
- We don't use the US postal service.
- Bidders with subzero feedback records will be canceled.
- Visit our new bulletin board.
- Please read our Warranty Statement
- Visit our home page
- Mechancial specifications: autocad DXF(186kb) or Adobe PDF (23kb)